![]() ![]() If you are using a boot floopy make sure you have two or three as floopys are very unreliable.Ģ) Prepare the target hard drive by starting a Windows XP installation. There is what I do to successfully move an XP installation to a new hard drive.ġ) Make sure you are using the latest version of ghost. You can read about this at microsofts knowledge base. XP does some special vodoo to your hard drive that is lost when you image it with Ghost. Windows XP won't clone, this is by design. I wrote a Drive Image Faqs a while back that might help:ī - Your Computer Questions Answered ![]() ![]() Note: Don't try to install the image file on a blank drive that has not yet been partitioned. Then you could access the image files, and install them on the new drive. Afterwards, you could install the older hard drive as a slave, and use the Drive Image floppies to start the system. Then you could back up your data to the new partition, and when imaging, place the image file(s) in the new partition. If you used FDISK to create the partition on the drive, remember that the partition must be the same size of larger than the imaged partition.ġ.) I'd run a thorough scan of the older hard drive before imaging, to check for file system errors.Ģ.) A possible solution could also be to use a partitioning program like Partition Magic to create a new partition on the older drive. If so, post back, and I'll send you a link on how to remove EZ-BIOS. This installs EZ-BIOS, and must be removed for many programs like Drive Image to function correctly. How did you install and partition the new hard drive? While I don't know if this is applicable in your situation, but if you used the Data Lifeguard Tools from Western Digital to partition the drive, you may have some problems due to the way the utility writes the partition tables. I use Nero to transfer the files to the CD's, and use the option within the program to check the validity of the data as it is burned. During the process, I make sure the image is valid when initially created, and then I re-check the image files on the CD-R disks to again be certain that the image is valid. Whenever I create an image, I always first place the spanned image files on the hard drive, and then burn the files on the CD-R disks. The reason that I'm asking is because there is a high probability of data corruption when burning directly to the CD-R disks. and if so, idirectly to the CD's, or did you burn the image to the hard drive, and then to the CD-R disks? Did you span the image and burn it to CD-R disks. It sounds like that when you used Drive Image, the image you created was not valid. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |